• AVR ISP Programmer, compatible with AT AVRISP mkII from ATMEL
• A professional In-System Programmer. Supports all AVR devices with ISP or PDI interface, including XMEGA
• Supports AVR Studio 4/5/6 or higher version (delivered with firmware for AVR Studio 5, can be updated to support other AVR Studio versions)

Features :

• Supports all AVR devices with ISP or PDI interface, and certain 51 Devices
• Programs both Flash and EEPROM
• Supports Fuses and Lock Bit Programming
• Based on AT AVRISP mkII firmware
• Upgradable to Support Future Devices
• Adjustable ISP programming speed up to 8M frequency
• USB 2.0 compliant (full speed, 12Mbps)
• 3 optional cables to target board
• Powered from USB bus, does not require external power supply

AT AVRISP mkII compliant

- Compatible with AT AVR ISP, easy to use, stable and reliable

Based on AT AVRISP mkII firmware

- Identified as AVRISP mkII in AVRStudio, high speed programming

Upgradable firmware

- Firmware is upgradable to Support Future Devices

- Automatic Upgrade

Supported software

- AVR Studio 4/5/6 or WINAVR(GCC) is used as front-end software

- Supports the program files generated by IAR, ICCAVR, CVAVR

Device Support

- USB AVRISP XPII supports all AVR devices with ISP and PDI Interface. Support for new devices will be added with new versions of AVR Studio.

- Supports AT86RF401/AT89S51/AT89S52

Performance

- High speed programs FLASH , EEPROM, Fuses, and Lock Bit

- It takes only 2.5S to program a 12K program file with verification (programming speed was set to 1M while the Max speed could be up to 8M)

Connects to PC

- Uses a USB interface for communication with the front-end software (Probably AVR Studio)

- Using PDIUSBD12, USB 1.1 (USB 2.0 Full Speed) 12Mbits/second

- Each USB AVRISP XPII has a unique ID, a PC could connects to several Devices at the same time

Connects to target board

The USB AVRISP XPII connects to the target board through 3 optional cables. Depending on the existed connector on the target board, the cable has to be changed accordingly.

- Standard 6-pin ISP Connector, Using 6-pin ISP cable

- Standard 10-pin ISP Connector, Using 6-pin to 10-pin ISP cable

- Custom ISP Connector, Using 6-wire multicolour custom connector cable

The figure 1 and 2 shows the pinouts for the 10-pin and 6-pin ISP connectors.

Powered from USB bus

- Draws power from the USB bus, No need for Additional Power Supply

- The target board should be powered from Another Power Supply

Downloads:

Development resources:user guide, software, etc.

Wiki: www.waveshare.com/wiki/USB_AVRISP_XPII

Package Includes;

• 1 x USB AVRISP XPII 
• 1 x USB Cable
• 1 x 6-pin cable (spare)
• 1 x 6-pin to 10-pin ISP cable
• 1 x 6-wire multicolour custom connector cable