This 16 MB HyperRAM + 32 MB HyperFlash add-on board is designed for use with Propeller 2 development board 2×6 accessory headers. Its dual 2×6 pass-through sockets stack on top of a pair of accessory headers on the P2 Eval Board (64000). It is also compatible with a P2 Edge Module Breadboard (#64020) or P2 Edge Mini Breakout Board (#64019) with a P2 Edge Module (#P2-EC) installed.

The P2-ES Eval Board HyperRAM & HyperFlash Add-on PCB comes fully assembled with surface-mount 16 MB HyperRAM and 32 MB HyperFlash, but supports all combinations of currently available hyper memory for users who prefer to change the memory configuration (de-soldering/re-soldering required) or to make their own from the open-source design files.

Features:

Dual hyper memory PCB populated with 16 MB HyperRAM and 32 MB HyperFlash
Dual 2×6-pin 0.1” passthough headers connect directly to P2 development board accessory headers
Optional hyper memory pins available on 0.1” pads for user configuration
PCB supports all combinations of hyper memory modules: 2x HyperRAM, 2x HyperFlash, 2x Dual-HyperRAM/Flash, or 1x HyperRAM with 1x HyperFlash (as sold)

Specifications:

RAM: 16 MB / 128 Mb (16 Mb x 8) Parallel PSRAM
Flash: 32 MB / 256 Mb (32 Mb x 8) Parallel NOR Flash
Voltage : +3.3 VDC (supplied by P2-ES Eval Board I/O LDO regulator)
Maximum clock rate : 100 MHz (200 MB/s) at 3.0 Vcc
RAM current: 60 mA peak burst, 600 µA standby (CS# = High)
Flash current: 100 mA peak burst, 25 µA standby (CS# = High)
Flash Endurance: 100,000 program/erase cycles
Flash Retention : 20-year data retention
Form factor: dual 2×6-pin female passthrough headers with 0.1″ spacing
Mounting hole: hole 2.5 mm (100 mil), pad ring 4.5 mm (180 mil) connected to GND
Operating temperature range: -40 to +185 °F (-40° to +85° C)
PCB dimensions: 1.0 x 1.9 in (25.4 x 48.3 mm)
PCB assembled, tested, and completed in Rocklin, California