The LIS3DH is a high performance, ultra-low power, three-axis linear accelerometer. It features user-selectable scales up to 16g, an embedded temperature sensor, 10-bit ADC and a standard digital I2C/SPI serial interface.

Parallax Inc. places the LIS3DH on a compact 20x21 mm PCB with an 8-pin straight header. The I/O connections operate at the same voltage supplied to the VIN pin for compatibility with both 3.3 V and 5 V microcontrollers. The Parallax module includes a low-noise 2.5 V regulator which matches the LIS3DH factory calibration voltage for the highest possible accuracy.

This LS3DH module is supported by the latest Propeller C libraries as well as dedicated BlocklyProp Solo blocks for easy visual programming.

Features:

Factory calibrated with 2.5 V low-noise regulator
User-selectable full scales of 2 g, 4 g, 8 g, 16 g
Hardware supports I2C, SPI 3-wire, & SPI 4-wire interfaces
Over-voltage, reverse polarity, and signal contention protection of all signal pins
VIN / GND reverse polarity protection
Compatible with 3.3 V and 5 V microcontrollers
Breadboard-friendly 8-pin header, plus 2 mounting holes

Application Ideas:

Motion activated functions
Free-fall detection
Intelligent power saving for handheld devices
Gaming and virtual reality input devices
Impact recognition and logging
Vibration monitoring and compensation

Key Specifications:

Power requirements: +3 VDC to +5 VDC; maximum 1 mA
Operating modes: High-resolution, normal mode or low-power
Typical current consumption at VIN = 3.3 VDC, 50 Hz Output Data Rate (ODR): 761 µA
Measurement ranges: ±2 g, ± 4 g, ±8 g, ±16 g
Measurement sensitivity: 1 to 192 mg/digit, depending on selected mode
Zero-g level offset accuracy: ±40mg
Zero-g level change vs temperature: ±0.5° mg/C
Temperature: range -40 to +85 °C; sensitivity 0.01%/°C, typical 8-bit resolution 1 digit/°C
32-level FIFO for each of the three output channels: X, Y, and Z
Communication: I2C (100 or 400 kHz) or SPI (3 and 4 wire, up to 10 MHz)
Operating temperature: -40 to +185 °F (-40 to +85 °C),
Form factor: 8-pin male header with 0.1" spacing
PCB dimensions: 20 x 21 mm
Mounting holes: Two holes suitable for #3 UNC (M2.5) hardware

Documents:

Package Includes:

1 x 3-Axis Accelerometer with ADC-LIS3DH

Parallax 29020 LIS3DH 3-Axis Accelerometer with ADC

Brand: Parallax Inc.
Product Code:Plx-29020-LIS3DH-Accelerometer
Reward Points:11
Availability:In Stock

रo 1,116.00
Price in reward points:1116
13 or more रo 1,107.00
27 or more रo 1,098.00
67 or more रo 1,089.00
133 or more रo 1,080.00

Qty

0 reviews / Write a review