The Mini Prototyping Add-on Board allows you to quickly solder together a custom peripheral for your Propeller 2 development system with a compatible accessory header.

The Mini Prototyping Add-on Board provides an 8×12 grid of plated thru-holes. Ground holes are connected on both sides of the PCB, and marked on the top side by white silk blocks.

Other holes that are joined are marked on the top side of the PCB with silk dashes or boxes. And they are linked on the bottom of the PCB with copper traces that are isolated clearly to enable easy cutting as required. Holes inside a white box are joined to the signal or power marked. Holes joined by dashes are joined together, but are not joined to any signal.

This board features a pass-through socket that stacks on top of a 2×6 accessory header on the Propeller 2 Evaluation Board (#64000). It is also compatible with a P2 Edge Module Breadboard (#64020) or P2 Edge Mini Breakout Board (#64019) with a P2 Edge Module (#P2-EC) installed.

Features:

8×12 grid of plated thru-holes
Power and I/O pin header access holes clearly marked
Silkscreen-marked common ground holes
Exposed ground strip on PCB back for easy bridging to ground
PCB Dimensions: 1.6 x 0.8 in (4.1 x 2 cm)

See the Product Guide download for explanatory diagram. Product guide, RoHS CE and UKCA Declarations of Conformity are available under the Downloads tab.

Documentations: