Best low-cost environmental sensing solution with BME280 and Si1132 on one board.

The combination of the BME280 sensor and the Si1132 sensor enables measuring temperature, barometric pressure and humidity, UV Index and ambient light at once.

6pin header socket is already soldered. You can simply plug it on to the right connector.

- Dimension is only 16.7 x 16.4 mm
- Sensors : BME280, Si1132
- Recommended working voltage : 1.75 ~ 3.6 Volt

- WiKi Pages (software and hardware guide)
Works with ODROID-SHOW2
Works with ODROID-C Series
http://odroid.com/dokuwiki/doku.php?id=en:wb_c_16x2lcd
Works with ODROID-XU4/3

Note:

The supplier of the product has no replacement and/or refund policy as part of their product warranty/guarantee. Furthermore, the repair cost and the cost of shipping to and fro from South Korea has to be borne. As Fab.to.Lab is merely an intermediary we extend the exact same warranty terms to all customers of Harkernel.

Please find more details here: Supplier warranty terms and conditions: https://www.hardkernel.com/agreement/

Pin	Name	Description
1	VDD	Input Voltage 1.75V to 3.55V
2	SCL	I2c Clock
3	SDA	I2c Data
4	ADC3	Do not connect
5	INT0	Interrupt output
6	GND	Ground

Key parameters for humidity sensor
- Accuracy tolerance ±4 % relative humidity
- Hysteresis ±2% relative humidity

Key parameters for pressure sensor
- RMS Noise 0.2 Pa, equiv. to 1.7 cm
- Offset temperature coefficient ±1.5 Pa/K, equiv. to ±12.6 cm at 1 °C temperature change

Hardware setup

Put your weather board 2 on the ODROID-SHOW2 and connect a micro-USB cable to your host PC or other ODROID Linux boards.

When the connection is established, you can find /dev/ttyUSB0 or similar one.

Connect a 750mAh Li-Po battery if you need a portable device.

Firmware setup

Download the sketch file and libraries from this link.
https://github.com/hardkernel/WEATHER-BOARD
Check the place of weather_board.ino sketch file.
ODROID-SHOW/firmware/weather_board/weather_board.ino
Select “preference” in the File menu and choose “ODROID-SHOW” of sketch folder.
To add proper libraries, Select Import library -> Add library and “ODROID-SHOW/libraries.
It’s time to build and upload the sketch file. The jumper(nearby reset button) must be installed. You will see this screen which shows various weather data.

More detail process is described on our WiKi.
http://odroid.com/dokuwiki/doku.php?id=en:weather-board

- ODROID-Show 2 + 750mAh Battery + Weather Board 2 : Make a portable weather station