• Cable length : 260-290 mm
• There is a small power switch on the ODROID-H2 board. But it is not easy to access the switch when you assemble(place?) the board in to a case. This beautifully illuminated power button is a good solution what you need!
• This button can be mounted on the official acrylic case Type-1, Type-2, Type-3 and Type-4.
• Note that the blue LED forward voltage must not exceed 3.5Volt.
• Red wire: LED positive (Anode) : pin-4 or pin-7 or pin-14 on 20 pin header of ODROID-H2
• Black wire: LED negative (Cathode) : GND(pin-1) on 20 pin header of ODROID-H2
• Blue wire : Switch-A : #PWR_BTN(pin-17) in 20 pin header of ODROID-H2
• Green wire : Switch-B: GND(pin-19) on 20 pin header of ODROID-H2

Note: 

The supplier of the product has no replacement and/or refund policy as part of their product warranty/guarantee. Furthermore, the repair cost and the cost of shipping to and fro from South Korea has to be borne. As Fab.to.Lab is merely an intermediary we extend the exact same warranty terms to all customers of Harkernel.

Please find more details here: Supplier warranty terms and conditions: https://www.hardkernel.com/agreement/

• 1 x LED Power Button