You’re probably itching to make some fun embedded computer projects with ODROID-C2 or C1+. What you need is an add on prototyping T-breakout board, which can break out all those tasty power, GPIO, I2C, ADC pins from the 40 pin header onto a solderless breadboard. This set will make “cobbling together” prototypes with the ODROID super easy.

With this T-type breakout board you can easily break out the GPIO pins of the ODROID-C1 on a breadboard to quickly start prototyping. The ribbon cable comes at the side of the breadboard so it won’t be in the way while working on yourproject.

• 1 x Assembled T-breakout PCB –  40Pin GPIO Breakout board
• 1 x Breadboard – 630 Tie-points with dual power lanes
• 1 x 40pin Ribbon cable – IDC Flat cable 100mm
• 1 x 40pin Male-to-Male Dupont jumper Wire 170mm
• 7 x Green LED 3mm
• 7 x Yellow LED 3mm
• 7 x Red LED 3mm
• 2 x Photo Cell (CdS Light sensor)
• 6 x Tact Swithc
• 50 x 330 Ohm 1/6W resister
• 50 x 10K Ohm 1/6W resister