Assembly Instructions

• Warning: Do not overtighten! Hand-tighten only at every step.
• Use a guitar pick or spudger to extract the HackRF One circuit board from the black plastic case.
• Insert one long screw into each corner of the bottom acrylic panel. Secure each long screw with a short (5 mm) spacer on the opposite side of the panel.
• Place the HackRF One circuit board (facing up) on top of the bottom panel, fitting the ends of the long screws through the corner mounting holes of the circuit board.
• Secure the circuit board with one long (6 mm) spacer in each corner.
• Place the top acrylic panel on top of the circuit board, aligning the cutouts with the circuit board’s expansion headers.
• Secure each corner with a short screw.

Package Includes:

• 1 x Acrylic Case for HackRF One