Flipper Zero is readily in stock

Flipper Zero is a portable multi-tool for pen-testers and geeks in a toy-like body. It loves researching digital stuff like radio protocols, access control systems, hardware, and more. It's fully open-source and customizable, so you can extend it in whatever way you like

Specifications:

• MCU (Microcontroller unit)
• Model: STM32WB55RG
• ARM Cortex-M4 32-bit 64 MHz (application processor)
• ARM Cortex-M0+ 32 MHz (network processor)
• Flash: 1024 KB
• SRAM: 256 KB
• Display
• LCD Monochrome
• Resolution: 128x64 px
• Controller: ST7565R
• Interface: SPI
• Diagonal Size: 1.4“
• Battery
• LiPo 2000 mA⋅h
• 7 days approximately

• Sub-1 GHz module
• Chip: TI CC1101
• TX Power: 0 dBm max
• Frequency bands (depends on your region):
• ● 315 MHz
• ● 433 MHz
• ● 868 MHz
• ● 915 MHz
• NFC
• Frequency: 13.56 MHz
• Supported cards:
• ● ISO-14443A/B
• ● NXP Mifare® Classic®, Ultralight®, DESFire® etc.
• ● FeliCa™
• ● NFC Forum protocols
• RFID 125 kHz
• Frequency: 125 kHz
• Modulation: AM, PSK, FSK
• Supported cards:
• EM400x, EM410x, EM420x
• HIDProx, Indala
• GPIO
• 3.3 CMOS Level
• Input 5V tolerant
• Up to 20 mA per digital pin

• Bluetooth LE 5.0
• TX Power: 0 dBm max
• RX Sensitivity: -96 dBm
• Data rate: 2 Mbps
• Micro SD
• Up to 64GB MicroSDHC
• Read/Write speed: up to 5 Mbit/s

• Buzzer
• Frequency: 100-2500 Hz
• Sound Output: 87 dB
• Type: Coin
• Vibration Motor
• Force value: 30 N
• Speed: 13500 rpm

• Infrared
• Force value: 30 N
• Speed: 13500 rpm
• Infrared
• TX/RX range: 800-950 nm
• TX power: 300 mW
• iButton 1-Wire
• Operate modes: Reader/Writer/Emulator
• Supported protocols:
•     Dallas DS1990A
•     CYFRAL
• Control
• 5-button joystick
• Back button
• Reboot — Back+Left buttons for 2 seconds
• USB
• 1x USB 2.0 port, type C
• USB device
• Charging
• Physical
• Size: 100 x 40 x 25 mm
• Weight: 102 grams
• Body materials: PC, ABS, PMMA
• Operating temperature: 0 ~ 40 °C

Package Includes:

• 1 x Flipper Zero