The jrk 21v3 motor controller is a highly configurable brushed DC motor controller that supports four interface modes: USB, logic-level serial, analog voltage, and hobby radio control (RC). The controller can be used with feedback for closed-loop speed or position control, or it can be used without feedback as an open-loop speed control. The continuous output current is approximately 3 A in the recommended operating range of 8–28 V, with derated performance down to 5 V and transient protection to 40 V. The board ships with connectors included but not soldered in, allowing for custom installations.

he jrk 21v3 is a versatile, general-purpose motor controller that supports a variety of interfaces, including USB. The broad operating range from 5 V to 28 V and continuous output current of 3 A (5 A peak) allow this board to control most small DC brushed motors. Analog voltage and tachometer (frequency) feedback options allow quick implementation of closed-loop servo systems, and a free configuration utility (for Windows) allows easy calibration and configuration through the USB port.

Key improvements over competing products and earlier Pololu motor controllers with feedback include:

  • USB connectivity with emulated serial (COM) port allows direct motor control from a PC.
  • Ultrasonic PWM to eliminate switching-induced motor shaft hum or whine.
  • Robust, high-speed communication protocol with user-configurable error condition response.
  • High internal resolution (12 bits) for smooth and flexible calibration to various input and feedback devices.
  • Current sensing and limiting.
  • Reversed power protection.
  • Field-upgradeable firmware.

Note: A USB A to mini-B cable (not included) is required to connect this controller to a computer.

Main Features of the Jrk 21v3

 

 

  • Simple bidirectional control of one DC brush motor.
  • 5 V to 28 V operating supply range.
  • 3 A maximum continuous current output (5 A peak).
  • Four communication or control options:
    1. USB interface for direct connection to a PC.
    2. Full-duplex, TTL-level asynchronous serial interface for direct connection to microcontrollers or other embedded controllers.
    3. Hobby radio control (RC) pulse width interface for direct connection to an RC receiver or RC servo controller.
    4. 0–5 V analog voltage interface for direct connection to potentiometers and analog joysticks.

  • Two closed-loop feedback options:
    1. 0–5 V analog voltage.
    2. Frequency/tachometer digital input up to 2 MHz with 1 ms PID period. 
      (Open-loop control with no feedback also available.)

 

 

  • Simple configuration and calibration over USB with free configuration program (Windows 8, Windows 7, Vista, and Windows XP compatible).
  • Configurable parameters include:
    • PID period and PID constants (feedback tuning parameters).
    • Maximum current.
    • Maximum duty cycle.
    • Maximum acceleration.
    • Error response.
    • Input calibration (learning) for analog and RC control.
  • Optional CRC error detection eliminates communication errors caused by noise or software faults.
  • Reversed power protection.
  • Field-upgradeable firmware.
  • Optional feedback potentiometer disconnect detection.
  • Comprehensive user’s guide.

Specifications

Motor channels: 1
Operating voltage: 5 – 28 V
Continuous output current: 3 A
Peak output current: 5 A
Auto-detect baud rate range: 300 – 115,200 bps
Available fixed baud rates: 300 – 115,200 bps
Available PWM frequencies: 20 kHz, 5 kHz
Reverse voltage protection?: Yes
USB connector style: USB Mini-B
 

 

Electrical Specifications
Output Current 3A
Minimum Operating Voltage 5 V
Maximum Operating Voltage 28V
Physical Attributes
Weight 0.23 oz
Dimensions 1392-1.35" x 1.35" x 0.4", 1394-1.35" x 1.35" x 0.5"
Additional Information
Warranty

Write a review

Please login or register to review

Pololu 1392/1394 Jrk 21v3 USB Motor Controller with Feedback

  • Brand: Pololu
  • Product Code:Pololu-Jrk-21v3-USB-Motor-Controller
  • Reward Points:85
  • Availability:In Stock
  • रo 8,533.00

  • Price in reward points:8533

  • 2 or more रo 8,465.00
  • 3 or more रo 8,397.00
  • 8 or more रo 8,328.00
  • 17 or more रo 8,260.00

Available Options


Related Products

L298N Motor Driver Board

L298N Motor Driver Board

The L298N driver module, using ST' L298N chip, can directly drive two 3-30V DC motor, and provide a ..

रo 195.00

L298P 2A Motor Shield For Arduino

L298P 2A Motor Shield For Arduino

This  DFRobot Arduino Compatible Motor Shield (2A) uses L298P chip which allow to drive two 7-12V DC..

रo 1,183.00 रo 1,364.00

L298N - Dual Full Bridge Driver

L298N - Dual Full Bridge Driver

The L298N is a high voltage, high current, dual full bridge driver designed to accept standard TTL l..

रo 150.00

L298 Dual H-Bridge Motor Driver

L298 Dual H-Bridge Motor Driver

Double H driver module uses ST L298N dual full-bridge driver, an integrated monolithic circuit in a ..

रo 2,121.00

Stepper Motor Driver A4988

Stepper Motor Driver A4988

A4988 is a complete microstepping motor driver with built-in translator for easy operation. This pro..

रo 140.00

4A Motor Shield

4A Motor Shield

The 4A Motor Shield is based on the Freescale MC33932 dual H-Bridge Power IC , which can control ind..

रo 4,619.00

USB2AX v3.2b

USB2AX v3.2b

The USB2AX is a small interface to control Dynamixel servos like the AX-12 from a computer. It plugs..

रo 5,066.00

Servo Six Board - Monk Make

Servo Six Board - Monk Make

The Servo Six board simplifies the process of connecting up to six servo motors to a Raspberry Pi or..

रo 667.00

1A Motor Shield for Arduino

1A Motor Shield for Arduino

1A Motor Shield for Arduino This Motor shield  for Arduino uses L293 chip which allow to dri..

रo 1,423.00 रo 1,639.00

Stepper Motor Driver - Easy Driver A3967

Stepper Motor Driver - Easy Driver A3967

Each Easy Driver can drive up to about 750mA per phase of a bi-polar stepper motor. It defaults to 8..

रo 210.00

Pololu 2134 / 2874 DRV8834 Low-Voltage Stepper Motor Driver Carrier

Pololu 2134 / 2874 DRV8834 Low-Voltage Stepper Motor Driver Carrier

This is a breakout board for TI’s DRV8834 microstepping bipolar stepper motor driver. It has a pinou..

रo 595.00 रo 676.00

Pololu 2971 DRV8880 Stepper Motor Driver Carrier

Pololu 2971 DRV8880 Stepper Motor Driver Carrier

This breakout board for TI’s DRV8880 microstepping bipolar stepper motor driver features adjustable ..

रo 955.00

Pololu Dual 2755/2756 MC33926 Motor Driver for Raspberry Pi

Pololu Dual 2755/2756 MC33926 Motor Driver for Raspberry Pi

This add-on board enables a Raspberry Pi B+, A+, Pi 2, or Pi 3 to drive a pair of bru..

रo 7,466.00

Pololu 1213 Dual MC33926 Motor Driver Carrier

Pololu 1213 Dual MC33926 Motor Driver Carrier

This dual brushed DC motor driver, based on Freescale’s MC33926 full H-bridge, has a wide operating ..

रo 6,932.00

Pololu 1212 MC33926 Motor Driver Carrier

Pololu 1212 MC33926 Motor Driver Carrier

This breakout board for Freescale’s MC33926 full H-bridge has an operating range of 5 – 28 V and can..

रo 3,730.00

Pololu 2130 DRV8833 Dual Motor Driver Carrier

Pololu 2130 DRV8833 Dual Motor Driver Carrier

This tiny breakout board for TI’s DRV8833 dual motor driver can deliver 1.2 A per channel continuous..

रo 1,275.00

Pololu 2135 DRV8835 Dual Motor Driver Carrier

Pololu 2135 DRV8835 Dual Motor Driver Carrier

This tiny breakout board for TI’s DRV8835 dual motor driver can deliver 1.2 A per channel conti..

रo 371.00 रo 421.00

Pololu 2511 DRV8835 Dual Motor Driver Shield for Arduino

Pololu 2511 DRV8835 Dual Motor Driver Shield for Arduino

This small shield is an easy, economical way to control two small brushed DC motors with an Arduino ..

रo 1,489.00

Pololu 2990 DRV8838 Single Brushed DC Motor Driver Carrier

Pololu 2990 DRV8838 Single Brushed DC Motor Driver Carrier

This tiny breakout board for TI’s DRV8838 motor driver can deliver a continuous 1.7 A (1.8 A peak) t..

रo 336.00 रo 381.00

Pololu 2961 MAX14870 Single Brushed DC Motor Driver Carrier

Pololu 2961 MAX14870 Single Brushed DC Motor Driver Carrier

This compact breakout board for Maxim’s MAX14870 motor driver offers a wide operating voltage range ..

रo 745.00 रo 847.00

Pololu 2960 BD65496MUV Single Brushed DC Motor Driver Carrier

Pololu 2960 BD65496MUV Single Brushed DC Motor Driver Carrier

This compact breakout board for ROHM’s BD65496MUV motor driver offers an operating voltage range of ..

रo 1,071.00 रo 1,275.00

Pololu 2136 DRV8801 Single Brushed DC Motor Driver Carrier

Pololu 2136 DRV8801 Single Brushed DC Motor Driver Carrier

This tiny breakout board for TI’s DRV8801 provides a modern alternative to classic motor drivers suc..

रo 1,087.00

Pololu 1112 Qik 2s12v10 Dual Serial Motor Controller

Pololu 1112 Qik 2s12v10 Dual Serial Motor Controller

This powerful motor controller allows variable speed and direction control of two large, brushed DC ..

रo 14,110.00

Pololu 1110 Qik 2s9v1 Dual Serial Motor Controller

Pololu 1110 Qik 2s9v1 Dual Serial Motor Controller

This small, inexpensive motor controller allows variable speed and direction control of two small, b..

रo 3,551.00

L298 Dual H-Bridge Motor Driver Module

L298 Dual H-Bridge Motor Driver Module

 New L298 Dual H-Bridge Motor Driver    Features:   Working mode: H bridge ..

रo 235.00

Pololu 3113 A-Star 32U4 Prime SV

Pololu 3113 A-Star 32U4 Prime SV

The A-Star 32U4 Prime SV is a programmable board based on Atmel’s ATmega32U4 microcontroller and arr..

रo 1,864.00

ULN2003 Stepper Motor Driver Board

ULN2003 Stepper Motor Driver Board

ULN2003 Stepper Motor Driver Board   A B C D four-phase LED indicates the status of the ..

रo 74.00

Pololu 767 TReX Jr Dual Motor Controller DMC02

Pololu 767 TReX Jr Dual Motor Controller DMC02

This lower-power, smaller, and lower-cost version of the TReX is the ultimate general-purpose motor ..

रo 14,110.00

Pololu 707/708 VNH2SP30/VNH3SP30 Dual Motor Driver Carrier MD03A 708 707

Pololu 707/708 VNH2SP30/VNH3SP30 Dual Motor Driver Carrier MD03A 708 707

The Pololu dual high-power motor drivers are compact carriers for the VNH3SP30 and VNH2SP30 motor dr..

रo 17,634.00

Pololu 3142 / 3143 / 3146 / 3147 / 3148 / 3149 Jrk USB Motor Controller with Feedback

Pololu 3142 / 3143 / 3146 / 3147 / 3148 / 3149 Jrk USB Motor Controller with Feedback

This compact motor controller makes closed-loop speed or position (but not both!) control of a brush..

रo 4,486.00 रo 5,098.00

Pololu 2133 / 2982 DRV8825 Stepper Motor Driver Carrier, High Current

Pololu 2133 / 2982 DRV8825 Stepper Motor Driver Carrier, High Current

This breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver features adjustable ..

रo 2,022.00

Tags: Pololu, USB Motor, Controller, Feedback

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments